Water Heaters
Water Heater InstallationWater Heater RepairWater Heater InspectionTankless Water HeatersTankless Water Heater MaintenanceRepiping & Water Lines
RepipingPipingWater Line InstallationWater Line RepairWater Line ReplacementWater Supply LinesSewer & Drain
Drain CleaningHydro JettingSewer Line InspectionSewer Line RepairSewer Line InstallationCast Iron Pipe Replacement & TunnelingFixtures
Faucet InstallationFaucet RepairToilet InstallationToilet RepairGarbage Disposal InstallationGarbage Disposal RepairWater Filtration
Water Filtration SystemsTD Plumbing Solutions replaces leaking and worn water supply lines across Benbrook and Greater Fort Worth, the short hoses that feed your toilets, faucets, washer, ice maker and water heater.
A burst braided hose under a sink can dump gallons on the floor before anyone notices. Swapping old lines costs little next to the damage one can cause. Terrill Dobbs checks each line and shutoff valve, replaces the ones at risk, and leaves the good ones alone.
Supply lines are easy to forget until one fails. You notice a drip under the sink, a damp spot behind the toilet, or a puddle by the fridge. Sometimes you notice nothing until a hose bursts. Checking them only takes a few minutes.
A slow drip at a supply line nut often shows up as a stained cabinet floor or warped wood.
A bulge means the inner hose is failing. Rusty braid means water has been getting in. Both are close to bursting.
The line from the wall valve to the tank can crack at the nut, especially older plastic ones.
Thin ice maker lines, often plastic, crack or pull loose when the fridge gets moved.
Washer hoses hold full pressure all day. When one bursts, water pours out until someone shuts it off.
A stuck valve means you can't stop a leak fast. Old valves are often replaced along with the line.
Found a bulging hose or a damp cabinet? Call and Terrill will tell you which lines need to go. Call (817) 229-9450 · Available 24/7 for emergencies
| Job | Typical time |
|---|---|
| One supply line swap | Usually under an hourLonger if the shutoff valve needs replacing too. |
| Whole-house line check | An hour or twoDepends on how many fixtures you have. |
| Water heater connections | About an hourIncludes a leak check once the tank refills. |
Typical ranges, not promises. Terrill tells you the real timeline once he has seen the job.
Terrill looks at each supply line and shutoff valve, noting bulges, rust, cracks and valves that won't turn.
He shows you what's failing and what's fine. You get the price before anything is swapped, and good parts stay.
Worn lines come out and new ones go in, sized to the fixture. Stuck or leaking shutoff valves are replaced if needed.
We turn the water back on, check each connection for leaks and show you where every shutoff is.
Talk to Terrill about your job in Benbrook. You get the fix and the price before any work starts. Emergencies are answered 24/7.
Supply line work is some of the least costly plumbing you can do, and it prevents some of the most costly damage. Terrill gives you the price before he starts, and he only replaces the lines that actually need it.
Doing several at one visit saves separate trips.
Stuck or leaking valves add a part and some time.
Tight spots behind toilets or deep sink cabinets take longer.
Ice maker, dishwasher and water heater lines take more work than a faucet line.
Every price is given before work starts. Larger jobs can be financed through Hearth.
Terrill replaces worn lines and leaves good ones alone. No upselling.
Terrill often sends photos or video so you can see exactly what was done.
A real person answers any time, day or night, for leak emergencies.
Terrill Dobbs, Texas Responsible Master Plumber RMP 45333, does the work himself.
When Terrill swaps your supply lines, he often sends photos or video of the finished connections, a habit his customers mention in their reviews.
Hard water is part of life in Benbrook and across Greater Fort Worth, and it's tough on the small parts of your plumbing. Minerals build up in shutoff valves until they stick, and supply line fittings wear out faster. A valve that hasn't been turned in years may not close when you need it.
Summer heat plays a part too. Water heaters in hot attics are common in DFW, and the lines on top of them sit in that heat all summer. Rubber washer hoses and older plastic toilet lines break down with age, so a quick look every year or two is worth it.
There's no fixed schedule, but check them every year or two. Replace any line that bulges, kinks, rusts or drips. Rubber washer hoses and plastic toilet lines tend to fail first. In hard water areas like Fort Worth, check shutoff valves too, since scale makes them stick.
Shut off the valve under the fixture right away. If it won't turn, shut off the main valve for the house. Then mop up and move anything that can soak up water. TD Plumbing Solutions offers 24/7 emergency service across Benbrook and Greater Fort Worth.
Yes. Ice maker lines are thin and often plastic, and they crack or pull loose when the fridge is moved. A plumber can replace the line and the valve that feeds it. TD Plumbing Solutions handles ice maker, toilet, faucet, washer and water heater lines.
A supply line is the short, flexible hose from a shutoff valve to one fixture, like a toilet or faucet. The water line is the buried pipe that brings water from the meter into your house. Both can leak, but they're two very different jobs.
Many homeowners can swap a simple faucet or toilet line if the shutoff valve works. Trouble starts when the valve is stuck, the fitting is corroded or the thread size is wrong. If anything feels forced, stop and call a plumber before a small job turns into a leak.
Braided lines hold up better than plain plastic or rubber, but they still wear out. The braid can hide a failing inner hose, so look for bulges, rust and kinks. Good lines with the right fittings, checked now and then, are the safest choice.
Older valves have a small seal around the stem that dries out over time. Turning a valve that hasn't moved in years can break that seal and start a drip. Sometimes tightening the nut behind the handle fixes it. Often, a new valve is the lasting fix.
If they're rubber and have been on a while, yes. Washer hoses hold full water pressure all the time, and a burst one keeps running until someone shuts the water off. Braided hoses, and turning the valves off when you're away, both lower the risk.
Pick your town for local details on water supply lines there, or call and Terrill will tell you straight what your home needs.
Drips, leaks, weak flow and stiff handles fixed at the source. Terrill tells you straight whether to repair or replace.
See this serviceRunning, weak, clogged or leaking toilets traced to the failed part and fixed, usually in one visit, with the price upfront.
See this serviceNew pipe runs, reroutes and damaged section replacement inside your home, for remodels, added fixtures and failed stretches of pipe.
See this serviceSee all of our plumbing services, read about plumbing financing through Hearth, or contact TD Plumbing Solutions.
Call and a real person answers. Tell Terrill what is going on and he will tell you straight what it needs.
